Description.
Here
is the circuit diagram of a battery eliminator circuit that can be
used as a replacement for 9V PP3 batteries. The circuit given here can
be used to power any device that operates from a 9V battery. The
transformer T1 steps down the mains voltage and bridge D1 performs the
job of rectification. Capacitor C1 is a filter. IC LM317T is the
regulator here. The value of R1, R2 and R3 are so selected that the
output voltage of IC1 will be steady 9 volts.
is the circuit diagram of a battery eliminator circuit that can be
used as a replacement for 9V PP3 batteries. The circuit given here can
be used to power any device that operates from a 9V battery. The
transformer T1 steps down the mains voltage and bridge D1 performs the
job of rectification. Capacitor C1 is a filter. IC LM317T is the
regulator here. The value of R1, R2 and R3 are so selected that the
output voltage of IC1 will be steady 9 volts.
Circuit diagram.
- Assemble the circuit on a good quality PCB.
- Transformer T1 can be a 230V primary, 9V secondary, 1.5A step down transformer.
- If 1A Bridge is not available, then make one using four 1N 4007 diodes.
- Do not connect loads that consume more than 1.5A to this circuit.
- A heat sink is recommended for IC1.
0 comments:
Post a Comment
Note: Only a member of this blog may post a comment.