• home
Home » , , » Car Battery Saver

Car Battery Saver

Prevents the complete discharge of the battery when the door is left open accidentally
I recently forgot to close the door of my car after parking in the garage and I found the battery completely exhausted after the week-end, when I tried to start the engine on Monday morning. This inconvenience prompted me to design a simple circuit, capable of switching-off automatically after a few minutes the inside courtesy lamp, the real culprit for the damage.
Circuit operation:
When the door is opened, SW1 closes, the circuit is powered and the lamp is on. C1 starts charging slowly through R1 and when a voltage of 2/3 the supply is reached at pins #2 and #6 of IC1, the internal comparator changes the state of the flip-flop, the voltage at pin #3 falls to zero and the lamp will switch-off. The lamp will remain in the off state as the door is closed and will illuminate only when the door will be opened again. The final result is a three-terminal device in which two terminals are used to connect the circuit in series to the lamp and the existing door-switch. The third terminal is connected to the 12V positive supply.

Car Battery Saver Circuit Diagram
Car Battery Saver Circuit Diagram

Notes:
  • With the values specified for R1 and C1, the lamp will stay on for about 9 minutes and 30 seconds.
  • The time delay can be changed by varying R1 and/or C1 values.
  • The circuit can be bypassed by the usually existing switch that allows the interior lamp to illuminate continuously, even when the door is closed: this connection is shown in dotted lines.
  • Current drawing when the circuit is off: 150µA.
Source: http://www.ecircuitslab.com/2011/06/car-battery-saver-circuit.html

0 comments:

Post a Comment

Note: Only a member of this blog may post a comment.